Series 1000

The Utility Controller is a Safety Device that regulates the control of various utility services and devices such as domestic water, natural gas, and electrical outlets within a science classroom, other instructional facilities, research and medical facilities.

LS & LX Series

The Remote Operation feature of our new LS and LX Series Utility Controller enables the Instructor to activate the Panic State or disable a service from anywhere within the classroom.

Series 5000/6000

The 5000 / 6000 Series Utility Controllers can be utilized to control multiple utility services, gases and electrical convenience outlets that are commonly used in either educational, research or medical facilities.

RA Controller

The RA Controller is designed to meet the needs of a school that wishes to upgrade the present control of the science classroom utilities without refurbishing the entire room.

LA Series

The LA Series Controller operates as a single or dual output controller where the application does not require the positive remote enabling authority or monitoring capabilities typically anticipated when specifying our Standard Utility Controller.

LA Series UL

LA Series 4000

The Time Delay “OFF” Controller operates as a single output controller where the application requires restrictive activation of a utility with a delay “OFF” after first activation.

The ISIMET Laboratory Service Panel operates as a single output controller incorporating either a solenoid valve assembly or electrical contacts along with the digital switching mechanism within a single enclosure. An internal junction box houses the 120-vac line voltage along with transformer and circuit board.

E Series

The E Series Enclosures are pre-assembled and wired enclosures intended for use with the ISIMET Utility Controller. Each contact point utilizes a master relay to control electrical outlets in the science classroom.

S Series

The S Series Enclosures are pre-assembled enclosures intended for use with the ISIMET Utility Controller.

Solenoids

These solenoids are rated for use with the Utility Controller when the installation procedures do not mandate a contained enclosure to house the solenoids. These solenoids are UL Recognized as companion components of the Utility Controller.

The unit is intended for installation into the shower’s supply piping, directly up-stream from the shower.
Activation of the shower automatically sends a Panic signal to the Utility Controller, thus placing the system into Panic.

The Remote Monitoring Station permits remote integration of the various ISIMET monitoring devices.

These ADD-ON Components enable the upgrade of an existing Utility Controller where the user desires additional components or operation to be added to an already installed system.

Time Control Unit provides the time sequencing feature common to systems that are  integrated with a building automation or management system “ems”.  Similar to those systems this unit includes a 7-day time switch that can be set to specific timing “ON” and “OFF” periods of operation

Remote Panic Assembly Panel

The IP-0 assembly features an Emergency Shut-off button that may be integrated with our Utility Controller where the panic feature has been omitted from the door panel or where room configuration requires an additional panic button assembly to be wall mounted. Units are provided with J-Box and mounting hardware.

Monitoring Light Arrays

The Monitoring Light Array is a wall mounted light unit intended for use as a visual indicator that circuits of the Utility Controller system are active.

Monitoring Beacon

Units are single light assemblies for mounting exterior of the classroom in a corridor.  Mounting the unit at a classroom doorway will provide immediate acknowledgement to occupants in the corridor that a potential emergency exists within the room.

Relays and Relay Enclosures

Use these Relays to connect devices for use with the ISIMET Utility Controller. Enclosures are available with relay and external switch (Model # IEx-R) or may be provided w/o the relay (Model # IEx). When ordering replace x with the number of relays needed in the enclosure.