ISIMET Logo

Utility Safety Controls Since 2000

ACCESSORIES/OPTIONS

S-Serles Companion Enclosure

S-Series Companion Enclosure

Learn More
  • Operates gas and water (options also available for compressed air, etc.)
  • Utilizes 1-4 solenoids
  • NEMA 1-rated metal cabinetry
  • Easy access for installation and maintenance
E-Series Companion Enclosure

E-Series Companion Enclosure

Learn More
  • Operates electricity
  • Contact points control electrical outlets
  • Up to 24 circuits
  • NEMA 1-rated metal cabinetry
  • Easy access for installation and maintenance
The LA Series Controller

The LA Series Controller

Learn More
  • Single or Dual switch controller
  • Restricts activation of utility; only teacher or authorized administrator can activate
  • Used in situations requiring only one or two utilities
Fuel Gas Sensor Control

Outdoor Grill Controller

Learn More
  • The Outdoor Grill Controller (OGC), located near a gas grill, provides gas to the grill. When the Gas ON button is pressed, gas flows to the grill. The OGC includes a “time-out” function that automatically disables gas after the time-out period. The programmable time-out period is usually four hours.
Fuel Gas Sensor Control

Fuel Gas Sensor Control

Learn More
  • Transmits signal to controller when fuel gas is detected; automatically turns gas off
Monitoring Beacon

Monitoring Beacon

Learn More
  • Mount in exterior of classroom (corridor)
  • Activated by panic button
  • Units are single light assemblies for mounting exterior of the classroom in a corridor. Mounting the unit at a classroom doorway will provide immediate acknowledgement to occupants in the corridor that a potential emergency exists within the room
Solenoids

Solenoids

Learn More
  • Normally closed
  • Quiet operation
  • Lead-free option available
  • Latching option available for hard or corrosive water areas
Emergency Shower

Emergency Shower
Monitor

Learn More
  • Notifies if water is flowing
  • This Monitoring Unit is equipped with a micro-flow switch , time-delay relay, and a two (2) foot control cable.
  • Unit is provided complete with junction box and mounting hardware. Connection to the Controller PC Board is made at the “Auxiliary Panic” Terminal for Series 100 or to "Isolated Panic" for Series 200. Unit is not intended as a stand-alone component. Refer to the RMS series Monitoring Units for stand-alone capabilities.
Gas Pressure Transmitter

Gas Pressure Transmitter

Learn More
  • Performs gas pressure stability test prior to initialization of gas. Disables gas if test fails/leak is detected.
Remote Panic Button

Remote Panic Button

Learn More
  • Automatically turns utilities off: accessible to all
Relay

Relays

Learn More
  • Used to connect devices to ISIMET utility controller
Remote Operator

Remote Operator

Learn More
  • Used in conjunction with the LAv2, the Remote Operator is a secondary control unit that does not require a second power supply.